Central Machinery 62291

Questions and Answers

R
Ruth DavenportAug 2, 2025
Why is the Central Machinery 62291 Log Splitter ram speed slow?
- A
  abbottandreaAug 3, 2025
  The slow ram speed when extending or retracting on your Central Machinery Log Splitter can be caused by several factors: * Moving the jack handles too slowly; try moving them at a faster pace. * Air in the oil; purge air from the splitter’s hydraulic system. * A damaged control valve, internal control valve leak, or internally damaged cylinder, which would require a qualified service technician to repair or replace the component.
R
russell94Aug 11, 2025
What to do if the Central Machinery Log Splitter ram will not move?
- C
  Craig MartinezAug 11, 2025
  If the ram on your Central Machinery Log Splitter won't move, it could be due to several reasons: * The handwheel is open; turn it clockwise until snug. * There's wedged wood or foreign objects under the ram; remove them. * The hydraulic lines or control valve are blocked; flush and clean the splitter’s hydraulic system. If these steps don't resolve the issue, the control valve or cylinder piston may be damaged, requiring a qualified service technician for repair or replacement.
A
Angel ThompsonAug 22, 2025
Why wood will not split in Central Machinery 62291 Log Splitter?
- C
  Carlos NguyenAug 23, 2025
  If the wood will not split, or splits extremely slowly, with your Central Machinery Log Splitter, consider the following potential causes: * Air in the oil; check for excessive air in the hydraulic reservoir. * Excessive control valve inlet vacuum; inspect the control valve inlet hose for blockages or kinks. If these steps don't resolve the issue, the control valve setting may be low, there may be an internal control valve leak, or the cylinder may be internally damaged, all of which would require a qualified service technician to diagnose and repair.