Central Pneumatic 64142 - Page 13

Page 13?*,)(.82<&80;)@+.'(&*<'A)3;.0'.)80;;)#BCCCBC!!BDEFE5Item 64142
GH?:IJKL:MHINKOPHNOI:OHOQ: G:IRL
V*0=&<7)(2.)I**;
IK)LM:%:OI)G:MNKRG)NO[RMJ)?MKP)HQQNW:OIHV)WNGQZHMT:A)U:?KM:)VKHWNOT1
i)S.0,)HOGNB033,*_.=)'06.(X)7*77;.')-&(2)'&=.)'2&.;='5)))
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
i)M.;.0'.)(2.)I,&77.,5
i)W.(082)(2.)0&,)'+33;X5
i)H((.93()(*)=&'820,7.)(2.)I**;)&<(*)0)3&.8.)*6)'8,03)-**=)(*).<'+,.)(20()
&()&')=&'8*<<.8(.=)0<=)&')&<8030/;.)*6)=,&_&<7)0<X)60'(.<.,'5
1. Depress the Magazine Latch and pull
back on the Moveable Magazine, sliding
it back to end of Fixed Magazine.
O*(.1 This Nailer/Stapler can drive
#!)T0+7.)?&<&'2)O0&;', #C)T0+7.)U,0=)O0&;'
and 18 Gauge 1/4″ Crown Staples. The various
type of fasteners are loaded in different ways.
2. To load #C)T0+7.)U,0=)O0&;', insert the
nails into the channel along the right-side of
the Fixed Magazine. Refer to Figure D.
FIG . 8
?&7+,.)W
3. To load #!)T0+7.)?&<&'2)O0&;', insert the
nails into the channel along the left-side of
the Fixed Magazine. Refer to Figure E.
FIG . 6
?&7+,.):
4. To load 18 Gauge 1/4″ Crown Staples,
insert staples from the top area of the Fixed
Magazine with one arm of the staples in the
center slot and the other arm along the Fixed
Magazine’s left side. Refer to Figure F.
F
IG . 7
?&7+,.)?
5. After the nails or staples are loaded,
slide the Moveable Magazine back into the
Fixed Magazine until the Magazine Latch snaps
back in place, securing the Moveable Magazine
and locking the fasteners into place.