To Next PageTo Next PageWhy is my Central Pneumatic 94847 Power Hammer operating at diminished pressure?
If your Central Pneumatic Power Hammer is operating at a diminished pressure, the cause may be that the air pressure is below the normal operating pressure. To resolve this, check the regulator on both the compressor and the Air Hammer.
General| Brand | Central Pneumatic |
|---|---|
| Model | 94847 |
| Type | Air Hammer |
| Air Consumption | 4 CFM |
| Operating Pressure | 90 PSI |
| Minimum Hose Size | 3/8 in. |
| Hose Size | 3/8 in. |
| Air Inlet | 1/4" NPT |
| Shank | 0.401 in. |
Maintain a clean, well-lit, and safe work area, wear protective gear, and dress appropriately for operation.
Ensure proper footing, disconnect air, stay alert, protect body parts, and use compressed air correctly.
Inspect parts, use correct replacements, follow maintenance advice, and ensure proper installation.
Secure the "C" Frame to a stable workbench, positioning the air hammer for optimal access to workpieces.
Connect the air supply to the switch assembly using appropriate fittings and hoses for tool operation.
Attach the air hammer assembly to the "C" frame, ensuring all components are correctly fitted and secured.
Adjust anvil height, set air pressure, and use the foot switch to operate the hammer for planishing metal.
Safely remove and replace anvils of different sizes onto the adjustable pole as needed for various tasks.
Addresses common problems like the hammer not operating or operating at diminished pressure, providing probable causes and solutions.
Clean components after use, lubricate the air line, and drain air compressor condensation for tool longevity.
Details the warranty coverage, exclusions, and procedures for returns and claims for defects.
