14
Using the Alarm Function
1. To deactivate the alarm, press the ALARM 1 or the ALARM 2 repeatedly until the
alarm icon disappears.
2. To activate the alarm, press the ALARM 1 or the ALARM 2 button again until alarm
icon appears.
3. To activate the snooze function, press the SNOOZE/DIMMER button on the unit (or
on Remote Control), following the sounding of the alarm. The alarm will then shut
off and will sound again after 9 minutes.
4. To turn the alarm off, press the STANDBY button on the unit or remote control. If
all settings remain the same, the alarm will turn on the following day at the same
time. When the alarm is not turned off after it sounds, it will then play for approxi-
mately 60 minutes and turn off automatically. This cycle will repeat every 24 hours
unless the settings are changed.
5. To prevent the alarm from coming on daily, press the ALARM 1 or the ALARM 2
button and set to off. The alarm icon will disappear to indicate that the alarm is
deactivated.
6. While listening to either FM radio or iPod/iPhone, if the alarm is activated with
buzzer, it will turn off after pressing the STANDBY.
NOTE:
· Set your iPod to the repeat mode if you’ve selected Wake To iPod/iPhone, if your
iPod/iPhone has less than one hour of songs.
· If you have selected the Wake To iPod setting, yet no iPod/iPhone present at the
alarm time, the unit will automatically switch to the buzzer mode.
· In order to wake to your iPod/iPhone , it must be appropriately placed in the built-in
universal dock.
· In the event of a power outage or if AC power is disconnected, when the unit is pow-
ered by the Backup Battery, time and date will not be displayed, however time and
date settings will be temporarily saved. The alarm will not sound.
Adjusting the Brightness of LCD Screen
To adjust the brightness of the LCD screen, press the SNOOZE/DIMMER button during
normal operation. Each press will change the brightness level of the LCD screen
OPERATIONAL INSTRUCTIONS
To Next Page
Loading...
