Centroid Acorn Plasma Users Manual Beta CNC12 v4.65 rev6
System Macros
Auto Z c:\cncm\system\auto_z_zero_macro.cnc Used by M61, a sub program that controls the
touch off cycle, do not edit this file.
Pierce c:\cncm\system\piercing_cycle_macro.cnc Used by M61, a sub program that controls the
piercing cycle, do not edit this file.
Torch Check c:\cncm\system\torch_check_macro.cnc This macro is used when the Torch check
button on the VCP is pressed while actively
running a Job.
Page 37 D:\Keith Documents\centroid_acorn_plasma_users_manual_draft27.odt rev27 3-15-22
To Next Page
Loading...