CeraGem PAUSE M2 - Assembly Method

98
02
1.
Safely remove all the parts enclosed in the box
.
(
Please make sure that there are no parts left behind
).
2.
Place it on a flat surface to avoid scratching
.
3.
Lay the product forward
,
and then insert the center connecting
support into the groove on the bottom of the product
.
*
Caution
:
Fit the rst side of the
'
center connecting support
'
to the xing device
.
4.
Insert the
'
four
-
foot support
'
all the way inside the xing device
.
*
When assembling and installing
,
put down the product slowly
.
If you rush this
procedure
,
there is a risk of damage to the product or personal injury
.
Assembly Method
Tension
controller
Foot rest rubber
Four
-
foot support
Center connecting
support
Joint support
Joint groove
Joint Fixture device
Body