Product details
Product guide – CESAB S200
34
Feature
The battery cover is made of metal
Benet
Robustness is further improved to withstand
rough impacts.
Driving features/programming the truck
The S200 trucks are highly manoeuvrable and offer individual setting options for
the operators. Settings that the operator can change himself are called operator
parameters. The trucks also have a machine register in which settings only can be
changed by a service technician. Please refer to the service manual for detailed
information. Upon delivery from the factory, the trucks are preprogrammed with
three different parameter settings. When switched on with PIN 1, the truck offers
optimal parameter settings for this truck type, with PIN 2 it is switched on in a slo-
wer mode, and with PIN 3 truck characteristics are set to maximum performance.
See all parameters in the parameter table.
Automatic back-up
All parameters are stored in the logic card and the motor controller.
Feature
Each time a parameter is changed, the system automatically backs up the data. This
takes approx. 3-5 seconds during which time log-out is impossible. If, for example,
the handle in which the logic card is housed needs to be replaced, then the service
technician will be asked whether the parameters stored in the motor controller or
the logic card should be stored in the new handle. If the technician in this case se-
lects the motor controller, then all existing truck settings will be stored in the new
handle.
Benet
Whenever a component needs replacement, current settings will not be lost. Apart
from the operator and service parameters, this also applies to the hour counters.
To Next Page
Loading...
Need help?
General
