CESAB S208L - Page 35

Product details
Product guide – CESAB S200
35
Operator parameters
To reprogram operator-specic parameters (if the change is permitted), proceed as
follows:
Press the horn button and keep it pressed while starting the truck using either
PIN code entry or the ID unit.
Release the horn button when the display shows “P”.
The parameter symbol on the display lights.
Use the speed control to scroll to the desired parameter.
Press the horn button once to change the value.
The parameter symbol on the display starts ashing.
Change the value by turning the speed control.
Conrm by pressing the horn button once more.
The parameter symbol on the display stops ashing and remains lit.
Complete programming by pressing "O” (red key) on the keypad or the ID unit.
●
●
●
●
●
●
●