CESSNA SECTION 4
MODEL 152 NORMAL PROCEDURES
1 July 1978 4-4
NOTE
Visually check airplane for general condition during walk-around
inspection. In cold weather, remove even small accumulations of
frost, ice or snow from wing, tail and control surfaces. Also, make
sure that control surfaces contain no internal accumulations of ice
or debris. Prior to flight, check that pitot heater (if installed) is warm
to touch within 30 seconds with battery and pitot heat switches on.
If a night flight is planned, check operation of all lights and make
sure a flashlight is available.
Figure 4-1
To Next Page
