MAINTENANCE & LUBRICATION
116
Maintenance Procedures
Engine oil check
Always check and change the engine oil at the intervals outlined in
the Maintenance Schedule.
1. Place the Vehicle on a level surface.
2. Start the engine and let it idle for (20~30) seconds. Stop the
engine.
3. Wait a short period for the oil to settle.
4. Remove access cover
1
by grasping the lower right portion
and pulling firmly.
5. Unscrew the oil dipstick
2
out and wipe off with a clean cloth.
6. Insert the dipstick into the oil filler hole. Do not reinstall it.
7. Remove the dipstick again and check the oil level indication.
Maintain the oil level between the upper and lower indicators.
8. Reinstall the dipstick into the oil filler hole, hand-tighten it, and
reinstall the access cover.
NOTE
Access cover grommets may come loose. Ensure they are in place
before reinstalling the cover.
1
2
MAX
MIN
To Next Page
Loading...
Need help?
General
