MAINTENANCE & LUBRICATION
131
3. Loosen the air filter clamp
4
and remove the air filter
5
.
4. Remove the foam pre-filter
6
from the air filter.
5. Wash the foam pre-filter gently with soap and water, and
allow it to completely dry.
6. Inspect the paper air filter and verify it is okay to reinstall.
Softly brush off accumulated dust if necessary. Install a new
filter as necessary.
NOTE
Do not wash paper air filters, or use compressed air to clean the
filter media.
7. Install the pre-filter onto the air filter. Apply a thin film of
lubricant on the inside diameter of the air filter rubber seal.
8. Install the air filter and clamp onto the air filter housing inlet.
Tighten the clamp securely.
9. Reinstall the air filter housing cover and spring clips. Verify
the cover is installed correctly and is sealing properly.
4 5
6
NOTE
The air filter element should be cleaned every 50 hours, It should be cleaned and lubricate more often if
the machine is operated in extremely dusty areas. Each time air filter element maintenance is performed,
check the air inlet to the air filter box for obstructions. Check the air filter element rubber joint to the
throttle body and manifold fittings for an airtight seal. Tighten all fittings securely to avoid the possibility of
unfiltered air entering the engine.
To Next Page
Loading...
Need help?
General
