&)0272
Pressure testing of
cooling system
Install the radiator cap tester to the radiator
cap;Apply the specified pressure (radiator
cap opening pressure) for 6 seconds.
Note
Do not apply pressure over the specified pr
essure [108kpa(1.1kgf/cm2)], or the coo
ling system may be damaged.In case there
is any pressure leakage, check the pipe,
joint parts, joints of waterpump and drain
age Replacing Coolant, Air Discharge
Preparation of coolant
Coolant is toxic, DO NOT drink or splash it
to skin, eyes, and clothes.
If coolant splashes in your eyes, thor-
oughly wash your eyes with water and con-
sult a doctor.
If coolant splashes on your clothes,
quickly wash it away with water and then
with soap and water.
If coolant is swallowed, induce vomit im-
mediately and see a physician.
Store the coolant properly and keep it
away from reach of children.
Note
Mix the coolant (undiluted) with soft water
according to the temperature 5 ę lower
than the actual lowest local temperature.
Coolant should be made from undiluted
coolant with soft water.
Standard density of coolant:
Recommended coolant: CFMOTO coolant
(Direct application without having to be
diluted) Drainage of coolant
Remove radiator cap cover
Note :Open the radiator cap after the cool-
ant is fully cooled. Remove:
Front top cover
Radiator cap. (
To Next Page
Loading...
