OPERATION OF YOUR ATV
77
Pre-Ride Inspection
Perform the following procedures before operation:
1. Fill the fuel tank with gasoline.
2. Place the vehicle on a level ground to check the engine oil level. Add recommended engine oil if
necessary to maintain the oil level between the minimum and maximum level marks of the dipsticks.
3. Drive slowly at rst. Select an open area that allows room to familiarize yourself with vehicle operation
and handling.
4. Vary throttle positions. Do not idle the vehicle sustainedly for long time.
5. Perform regular checks on fluid levels,controls and items outlined on the daily pre-ride inspection
checklist.
6. Pull the load under the maximum weight requirement.
7. During the break-in period,change both the oil and oil lter at 20 hours or 320km .
WARNING
If a proper inspection is not done before each use,severe injury or death could result. Always inspect the
vehicle before each use to ensure it is in proper operating condition.
To Next Page
Loading...
Need help?
General
