148
MAINTENANCE
9. Remove the oil lter cover fasteners
4
and cover
5
from the
crankcase.
10. Remove the oil lter cartridge
6
from the crankcase housing.
11. Install a new oil lter cartridge in the crankcase housing.
12. Inspect and verify the cover O-ring
7
is okay to reuse, and
then install it into the groove of the crankcase housing correctly.
13. Install the oil lter cover and fasteners. Tighten the fasteners to
7.3 ft-lb. (10 N•m).
14. Add the specified amount of recommended engine oil, and
then reinstall the engine oil dipstick and hand-tighten it.
NOTE:
Oil change with oil filter: 3.06 qt. (2.9 L) Maintain the oil level
between the upper and lower indicators.
The 800 engine contains a wet clutch assembly, which requires
the use of JASO-certied engine oil. To avoid damage to the wet
clutch, always use JASO-certified engine oil, commonly sold as
motorcycle engine oil.
15. Start the engine and allow it to run for 2-3 minutes. While the
engine is running, check for oil leaks. If an oil leak is found,
turn the engine o immediately and check for the cause.
16. Turn the engine off. Recheck the oil level and correct it if
necessary.
4
5
7
6
To Next Page
Loading...
