74
CONTROLS AND FEATURES
Horn Button -
8
Press the button “ ”. The horn will sound.
Low Beam / High Beam Switch -
9
High Beam is selected when the switch is in this position.
Low Beam is selected when the switch is in this position.
Main Light Switch -
10
The main light switch consists of 3 positions:
Head lights and tail lights ‘ON’ when the switch is in this position.
Head lights ‘OFF’ and tail lights ‘ON’ when the switch is in this position.
● Head lights and tail lights are ‘OFF’ when the switch is in this position.
NOTE:
Ignition key must be turned to ‘ON’ before operating head lights.
CAUTION
Do not use the headlights with the engine turned o for more than 15 minutes. The battery may discharge
to a point that the starter motor will not operate properly. If this should happen, remove the battery and
recharge it.
To Next Page
Loading...
