33
APPENDIXPIÈCES DÉTACHÉESMAINTENANCE & ADJUSTMENTS
INSTALLATION OF FLOATING BLOCK
The following diagrams is limited to use of the floating blocks when the robot cannot
climb the pool walls or is not able to climb walls like it used to.
• Open the filter cover and pick up the filter basket.
• Tear o the protective film on the back of the floater and stick one by one according to
the position shown in the figure.
• Install the filter basket and close the filter cover. Wait for 24h before putting the cleaner
back in the pool.
If your robot is performing well, please ignore these instructions.
To Next Page
Loading...