CGX Quick-20r - Page 2

2
Warnings
TheQuick-20risintendedtobeused
toacquiretheelectroenchephalogram
(EEG)andtransmititwirelesslytoa
computer.
ThisDeviceIsIntendedForResearchOnly.
ItIsNotIntendedForTheFollowingUses:
• monitoring of patients in a clinical
environment
• use in medical diagnosis
• on subjects undergoing surgery
• use in sterile environments
• use with sleeping subjects
DoNotUseThisProductInThese
Situations:
• near high-frequency surgical equipment
• if exposed to ionizing radiation
• in oxygen-rich environments (concentration
> 25% at 1 atm)
• in wet environments
• in the presence of ammable anesthetics
or gases
PrecautionsForThePractitioner
• Do not drop, sit on, step on, fold, push,
pull or stretch the product.
• Check if your subject has a sensitive
dermatological condition causing sensor
intolerance.
• To avoid cross-subject contamination, do
not use with subjects having open wounds
or scalp infections.
• The Quick-20r headset is not a diagnostic
tool. Any medical diagnosis related to
the EEG should be derived by a certied
physician.
SubjectConsiderations
• This device is intended for human use only.
• Subject should have a healthy scalp.
• This device ts teens and adults with a
head circumference from 52 to 62 cm.
• Do not use with infants or neonates.
• Test subjects may or may not have hair.
• All sensors must be able to contact the
subject’s scalp.
• The entire headset may come into contact
with the subject’s skin.
FollowTheseAdvisoriesToKeepYour
Quick-20rInGoodWorkingOrder
• Do not immerse the headset in liquid.
• Do not expose the headset to direct
sunlight or heat source, moisture, vibration,
mechanical shock, excessive dust, or
humidity.
• Do not open, modify or disassemble the
headset — this will void the warranty.
• Do not use if the headset is damaged.
• Do not use when wet — if moisture
penetrates the headset, remove the
batteries and let it thoroughly dry prior to
use.
• Do not use caustic or abrasive cleaners on
the headset or sensors.
• Avoid sharply bending the legs.
DisposableSensorsMayBeA
Biohazard
• Store clean sensors in the provided jars.
• Clean sensors after each session following
instructions on Page 13.
• Replace sensors at or before their stated
lifecycle limits (Specications, Page 26), or
if they appear worn.
AlwaysUseSuppliedAccessories
Using accessories other than those supplied
with your Quick-20r system may result in
damage or diminished ecacy of the system.
The Quick-20r uses two AA Alkaline or
NiMH batteries. Follow care and handling
instructions provided by the battery
manufacturer.
AvoidCross-SubjectContamination
Clean the device and clean or replace
sensors after use following the cleaning
instructions on Page 13 to avoid cross-
subject contamination.