Chaffoteaux & Maury Celtic FF - Rear Flue Outlet

1.4.1
1.4.2
Side Flue Outlet
To cut flue assembly to length
- Measure from external wall face to centre line of
external
internal
FM
Celtic and subtract 37 mm (this will give required
wall face
wall face
length ‘I”).
IL) L 50
- Cut off surplus from plastic air duct (plain end).
mm,
N-6. If extension sections are used ensure these are
.-I 1
I
*j -_--- )--
“--P,
--t-l-f-
firmly pushed together.
1
- Cut same amount off aluminium flue duct (plain
L-&L- 7
end).
Flue extension accessory
L
Par-t NO. 61061
700 mm max. (standard length)
(I metre length)
q 1 1
13mm -I /y/q- 55 mm 1
9 I
r--
295 ’ mm
min
min.
min.
Fig. 3
SIDE OUTLET ASSEMBLY
cut off
from this end
ci
I-
_ - _I
<- 7,
\
I I
\
a-
L
:
-----c
standard 2 part flue duct
Fig. 3a
PLASTIC AIR DUCT ALUMINIUM FLUE DUCT Fig. 3b
1.4.3
Other flue arrangements
Rear Flue Outlet
To cut flue assembly to length
- Measure wall thickness (T).
- Add 74 mm, this will give required length CL).
- Mark plastic air duct for length (L) and cut off sur-
plus (from plain end).
N.B. If extension sections are used ensure these are
firmly pushed together, see figs. 3b and 3c.
- Cut off same amount from aluminium flue duct
(plain end).
Flue extension accessory
Part No. 61061
(I metre length)
Fig. 2
REAR OUTLET ASSEMBLY
1. Distance from internal corner 300 mm without
kit, 150 mm with kit no. 76216 (GC No, 264 833).
OE
WI
L”E
? 5
OE
L”E
f
1
\
2
Fig. 3c
2. Distance below balconies or eaves 200 mm
without kit, 150 mm with kit no. 76216 (GC No
264 833).
3. Appliance is normally supplied packed with
standard 650 mm straight flue section. Addi-
tional straight extention lengths of 1 metre. Part
No. 62823 (GC No 264 459), can be used up to a
total straight length of 3 metres. It is also possible
to incorporate one bend in the flue using Part
No. 65572 (GC No. 264 835). In this case the
length Ll + L2 should not exceed 1,6 metres
horizontally.
4