InstructionsInstructions
This product is designed to operate on 230VAC 50Hz. Connecting it to another
source may cause damage.
The line trimmer may be fitted with a non-rewirable plug. If it is necessary to change
the fuse of the plug the fuse cover must be refitted afterwards. If the fuse cover is lost
or damaged the plug must not be used until a suitable replacement is obtained.
The wires in the power cable of this product are coloured as follows:
• Blue= Neutral
• Brown=Live
If the colours of the wires in the power cable of this product do not correspond with
the terminals on your plug proceed as follows (see the wiring diagram below).
• The Blue wire must be connected to the terminal which is marked N or
coloured Black.
• The Brown wire must be connected to the terminal which is marked L or
coloured Red.
There are no user-serviceable parts inside – always refer to qualified service
personnel.
Do not allow this product to be exposed to rain or moisture during use or storage.
Plug should be BS1363/A approved. Fit a 5 Amp fuse.
Ensure that the outer sheath of the cable is firmly held by the clamp.
Electrical safetyGeneral maintenance
Cleaning
To ensure the best performance from the line trimmer, it must be kept clean.
Clean the line trimmer immediately after use, remove grass trimmings and other debris
from the spool holder, guard and cooling vents.
Do not allow grass cuttings to become dry and hard on any of the line trimmer surfaces
as this directly affects cutting performance.
Storage
Once the line trimmer has been thoroughly cleaned store it in a clean, dry place out of
the reach of children.
Environmental protection
Where possible recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycling centre and
disposed of in an environmentally friendly manner.
To Next Page
Loading...
Need help?
General
