AP11LCD / AP11LED Manager Guide
AP11LED/LCD-Manager- Rev 02
28
Appendix 1 – Event Log Messages
Keypad text Description
Power up Supply power on
Engineer Start Enter engineer program mode
Engineer End
Leaving engineer program mode
Code Change User N code be changed
Battery Low Battery low voltage
AC Mains Failed Mains power supply failure
AC Mains OK Mains power supply restored
Battery OK Battery voltage normal
Service Due Service Time expired
Program SET User has set the system with program Full. Part 1, or Part 2
System SET System into Set mode
System Unset User has unset the system
Key SET Keyswitch set the system
Key Unset Keyswitch unset the system
Unset from Alarm User has unset the system from alarm
Intruder Alarm Intruder zone activated (opened)
Entry Start Entry time started
Entry Deviate Entry time Deviate ( Immediate zone activated)
PANIC Alarm Panic zone activated (opened)
Fire Alarm
Fire zone activated (opened)
RKP Tamper RKP tamper opened
Detect Tamper Detect tamper opened
CP Tamper Control panel tamper opened
Bell Box Tamper Bell box tamper opened
Code Tamper Invalid user code was entered
Tamper Alarm
Zn: Zone n
24h/Tamper zone activated (opened)
Zone Tamper
Zn: Zone n
EOLR Zone tamper opened
To Next Page
Loading...
Need help?
General
