Chamberlain 893LM User Manual

Single Button Remote Control
Model 891LM
3-Button Remote Control
Model 893LM
TO ERASE ALL CODES FROM MEMORY
REMOTE CONTROLS
MODELS 891LM & 893LM
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate,
or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are
no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to
cross path of moving gate or door.
Press and hold the button
on the remote control
that you wish to use.
“click”
“click”
Release the button
when the garage
door opener lights
blink or two clicks
are heard.
If programming to
other products,
press the button a
second time to
activate the product.
Locate the
Learn button.
Press and
immediately release
the Learn button.
The Learn LED will glow
steadily for 30 seconds.
Within 30 seconds...
PROGRAM USING THE GARAGE DOOR OPENER
For use with Security+ 2.0™ products. All Security+ 2.0™ Garage Door Openers have a yellow Learn
button and two yellow antennas. The code between the remote control and the receiver changes
with each use, randomly accessing over a billion new codes. Refer to your product manual for the
location of the learn button.
NOTE: Your product may look different than the products illustrated in this manual.
When deactivating any unwanted remote
control code, all previous codes will be
erased.
Press and hold the Learn button on garage door opener
or other product until the learn LED goes out
(approximately 6 seconds). All previous codes are
now erased. Reprogram each remote control you
wish to use.
LED
LED
Press the LEARN button again,
the LED will flash once.
Press the LEARN button on
the door control to enter
Programming Mode.
The command LED
will flash once.
The command LED
will flash once again.
Press and hold the button
on the remote control
that you wish to use.
“click”
“click”
Release the button when
the garage door opener
lights blink or two clicks
are heard.
If programming to other
products, press the
button a second time to
activate the product.
PROGRAM USING THE DOOR CONTROL
For more information, please visit www.devancocanada.com or call toll free at 855-931-3334

Chamberlain 893LM Specifications

General

Brand	Chamberlain
Model	893LM
Category	Remote Control
Language	English

Summary

LiftMaster Remote Controls 891LM & 893LM

Program Garage Door Opener

Step-by-step guide to program remote controls to the garage door opener unit.

Program Using Door Control

Instructions for programming remote controls using the door control panel.

Erase All Codes From Memory

Procedure to clear all previously programmed remote control codes from the opener.

General Safety Warnings

Preventing Serious Injury or Death

Crucial safety warnings to prevent serious injury or death from moving garage doors.

Control Garage Door Opener Lights

Program Remote for Lights

Guide on programming a remote button to control garage door opener lights separately.

Remote Control Battery and Operation

Remote Control Battery Replacement

Detailed steps for replacing the battery in the remote control unit.

Remote Control Operation

Explanation of how to use the remote control for operating the garage door.

3-Button Remote Control Functions

Information on programming additional buttons for other devices.

Product Information and Warranty

Replacement Parts

List of available replacement parts for the remote control.

One Year Limited Warranty

Details of the manufacturer's one-year limited warranty for the product.

How to Order Repair Parts

Ordering Parts from Devanco Canada

Instructions on how to order repair parts, including required information.