Chamberlain LiftMaster 361LM - User Manual

To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted, and
there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
INTRODUCTION
This product is for use with gate operators, commercial door operators and any LiftMaster
®
product
that uses a 315 MHz fixed code. The single-button remote control will activate one device, the
2-button remote control will activate up to 2 devices, and the 3-button remote control will activate
up to 3 devices.
Model 361LM & 361LMC
Model 362LM & 362LMC
Model 363LM, 363LMC,
333LM, & 333LMC
Locate the Dip Switches on Your Remote Control
BEFORE YOU BEGIN
Locate the Smart/Learn Button for Your Product
Single-Button and 3-Button
Remote Controls:
Slide the battery cover open to access the dip
switches in the remote control.
2-Button Remote Control:
The 2-button remote control has two sets of
dip switches.
Slide the battery cover open to access the dip
switches for the smooth button. Remove the
screw on the back of the remote control and
remove the cover by pressing the tab. This will
access the dip switches for the ribbed button.
+ 0 –
123456789
+ 0 –
123456789
+ 0 –
123456789
Tab
1
Single and 3-Button Remote Controls
2-Button Remote Controls
NOTE: Your product may look different than
the products illustrated.
The Smart/Learn button is typically located on
the logic board of the operator or external
receiver. Refer to your product owner’s manual
for the exact location of the Smart/Learn
button.
Smart/Learn Button

Summary

LiftMaster Remote Control Introduction and Preparation

Product Introduction

Details product use with gate/commercial door operators and its 315 MHz fixed code capability.

Before You Begin: Locating Key Components

Guides on finding dip switches and the Smart/Learn button on remote controls and operators.

Setting Dip Switches and Programming Remotes

Set the Dip Switches

Instructions for setting dip switches without or with an existing remote, and for 3-button remotes.

Programming Procedure

Steps to program a remote by activating the Smart/Learn button and the remote button within 30 seconds.

Specific Programming for Model 333 LM

Programming Model 333 LM Only

Detailed steps for programming 333LM remotes to a 3-channel receiver for OPEN, CLOSE, and STOP modes.

Remote Control Battery and Replacement Parts

The Remote Control Battery

Information on battery lifespan, safety warnings, and proper disposal of 12-volt batteries.

Replacement Parts

Lists available replacement parts, including visor clips and 12V batteries, with part numbers.

How to Order Repair Parts

Ordering Information

Contact details and required information for ordering repair parts from DEK CANADA INC.

Chamberlain LiftMaster 361LM Specifications