Need help?Do you have a question about the Chameleon Antenna CHA MPAS 2.0 and is the answer not in the manual?
General| Connector Type | SO-239 |
|---|---|
| Impedance | 50 Ohms |
| Polarization | Vertical |
| Gain | Varies with Frequency |
| Operating Temperature | -40°C to +70°C |
| Power | 100 Watts |
The Hybrid Micro provides a mounting base and impedance matching for the CHA MPAS 2.0.
The Antenna Wire is a 73-foot length of black insulated wire wound on a line winder.
Loops attached to the antenna wire for suspension.
A removable pear-shaped stainless-steel hook used for mechanical connections.
Stores antenna wire and counterpoise wire for rapid deployment.
Terminal lugs for connecting antenna and counterpoise wires.
SO-239 connector on the Hybrid Micro for cable connection.
3/8" x 24 female fitting on top of the Hybrid Micro for antenna connection.
3/8" x 24 male fitting on the bottom of the Hybrid Micro for mount connection.
Shackle, bolt, and nut assembly attached to the top of the Hybrid Micro.
25 feet of wire with a connector, wound on a line winder.
Stainless-steel spike for in-ground mounting of the vertical antenna.
Electrical connection point for the counterpoise wire.
Mechanical connection point for the Hybrid Micro on the Spike Mount.
Military-style collapsible whip antenna for use with Hybrid Micro.
Connects the whip antenna to the Hybrid Micro.
Increases whip antenna length for better performance on lower frequencies.
Connects the whip antenna to the antenna extension.
Configuration for man-packable, omnidirectional, ground wave communication.
Configuration for portable, omnidirectional, ground and sky wave communication.
Configuration for good NVIS propagation on lower frequencies.
Configuration for general-purpose, omnidirectional to unidirectional HF antenna.
Configuration for unidirectional HF antenna, favors end of horizontal part.
Configuration for bidirectional HF antenna, favors broadside.
To Next Page
