Champ CF Series User Manual

K:\Products\Packing\BC\BC-PL788-CF,SD\ChampBarcodeScannerQuickStartGuide.doc
1
Champ CF/SD Barcode Scanner
Quick Start Guide
Hardware (LED Green) – Power on
1. Connect your Pocket PC to the computer with Microsoft Active Sync program is
installed.
2. Insert the system CD that come with the barcode scanner into the CD-Rom drive of
your computer and start the setup program.
3. Insert the CHAMP CF or SDIO Barcode Laser Scanner into the Pocket PC Compact
Flash or SDIO Slot.
Note: Make sure you have soft reset your device after software installation before you insert the
card.
4. Clicking Barcode Keyboard Emulator icon on Program Menu.
A beep should sound . Then click the “OK “ icon to open Barcode Tigger
You will find list on bottom of your PDAs .
5. Scan Data into Your Application

Champ CF Series Specifications

General

Brand	Champ
Model	CF Series
Category	Barcode Reader
Language	English

Summary

Hardware Installation and Power On

Connect and Install Scanner Components

Connects Pocket PC, installs software from CD, and inserts scanner card.

Launch Barcode Keyboard Emulator

Opens the Barcode Keyboard Emulator icon from the Program Menu.

Scanning Data into Applications

Prepare Application and Scan Barcode

Starts a Windows application and scans a barcode using the trigger button.

Confirm Scan Results and Feedback

Details scanner feedback (beep) and how data appears in the application.

Exit Barcode Keyboard Emulator

Provides instructions to close the Champ Barcode Keyboard Emulator program.

Emulator Restart Requirement

Notes that the emulator must be rerun after the Pocket PC is powered off.

Assign Trigger Button on Pocket PC

Navigate to Button Settings

Guide to access button configuration via Start > Settings > Buttons.

Assign Emulator to Hardware Button

Assigns the Barcode Keyboard Emulator to a specific Pocket PC hardware button.

Trigger Button After Power Cycle

Explains how to use the assigned trigger button after Pocket PC power cycling.