To Next PageTo Next PageWhy does my Champion Power Equipment Water Pump shut down during operation?
If your Champion Power Equipment Water Pump shuts down during operation, it could be due to a couple of reasons. Check if the fuel tank is empty and fill it up if needed. Also, verify that the oil level is sufficient and fill the crankcase to the proper level. Ensure the water pump is placed on a flat, level surface.
What to do if Champion Power Equipment Water Pump is overheating?
If your Champion Power Equipment Water Pump is overheating or performing poorly, start by checking the strainer or hose for any clogs and remove any debris. Ensure the pump is properly primed. Verify that the suction hose is fully submerged in water. Make sure you have not exceeded the head limit. Relocate the pump so the suction head is less than the discharge head (maximum 98 feet). Check for air leaks and tighten connectors and clamps or replace seal packing, and or apply more telfon tape as needed.
Why Champion Power Equipment Water Pump won't start?
If your Champion Power Equipment Water Pump won't start or runs roughly, check these potential issues: Ensure the oil level is adequate by filling the crankcase to the proper level, and place the water pump on a flat, level surface. Verify the choke is in the correct position and adjust it if necessary. Also, make sure the spark plug wire is securely attached to the spark plug.
General| Engine Type | 4-Stroke OHV |
|---|---|
| Max Flow Rate | 158 GPM |
| Maximum Suction Height | 26 ft |
| Fuel Type | Gasoline |
| Starting Method | Recoil |
| Self-Priming | Yes |
| Solids Handling | No |
| Inlet Size | 2 in |
| Outlet Size | 2 in |
| Suction Size | 2 in |
| Discharge Size | 2 in |
Warns about CO poisoning from exhaust and the need for proper ventilation.
Covers risks from rotating parts, recoil cord, hot surfaces, and pump force.
Details gasoline hazards and safe handling, storage, and refueling procedures.
Addresses fire risks, electrical shock, and limitations on water types.
Instructions for safely adding gasoline to the fuel tank.
Instructions for filling the engine with the correct type and amount of oil.
Step-by-step instructions to fill the pump with water for operation.
Step-by-step guide to starting the water pump engine using choke and primer.
Procedure for draining and refilling the engine oil.
Recommended service intervals for various maintenance tasks.
Details pump dimensions, capacity, and engine model, displacement, and spark plug.
Covers recommended fuel, oil type/capacity, and operating temperature ranges.
Lists common issues like starting problems, overheating, and solutions.
