To Next PageTo Next PageWhy Champion Power Equipment Log Splitter engine will not start or runs roughly?
If your Champion Power Equipment Log Splitter engine either won't start or runs roughly, check a few things. Ensure the oil level is sufficient by filling the crankcase to the proper level. Also, make sure the log splitter is placed on a flat, level surface. Adjust the choke, and ensure the spark plug wire is securely attached to the spark plug.
How to fix Champion Power Equipment 90720 Log Splitter when engine will not start?
If your Champion Power Equipment Log Splitter engine won't start, make sure it has fuel by adding fuel to the tank. Also, check the spark plug and replace it if it's faulty. Ensure that the unit isn't loaded during start up; remove any load from the unit.
What to do if Champion Power Equipment 90720 engine will not start; Engine starts but runs roughly?
If your Champion Power Equipment Log Splitter engine won't start or runs roughly, check the oil level and fill the crankcase to the proper level. Make sure the log splitter is on a flat, level surface. Adjust the choke, and ensure the spark plug wire is securely attached to the spark plug.
What to do if Champion Power Equipment 90720 engine shuts down during operation?
If your Champion Power Equipment Log Splitter engine shuts down during operation, it could be due to a few reasons. Make sure the fuel tank is full. Also, check the oil level and fill the crankcase to the proper level if it's low. Ensure the log splitter is placed on a flat, level surface.
What to do if Champion Power Equipment 90720 wedge movement is slow or erratic?
If the wedge movement on your Champion Power Equipment Log Splitter is slow or erratic, it could be due to a few reasons. You may have air in the hydraulic oil system, in this case purge the air by extending and retracting the wedge several times until the motion is smooth. There might be debris lodged in the beam guides, so clear the debris from the beam. Also, check the hydraulic oil level and add as needed.
Why Champion Power Equipment 90720 engine cannot supply enough power or overheating?
If your Champion Power Equipment Log Splitter engine cannot supply enough power or is overheating, it might be due to insufficient ventilation. Check for any air restrictions and move the log splitter to a well-ventilated area.
What causes Champion Power Equipment 90720 wedge to not auto-return?
If the wedge on your Champion Power Equipment Log Splitter does not auto-return, check the hydraulic oil level and add as needed. For a faulty control valve you should contact Customer Service.
What to do if Champion Power Equipment 90720 Log Splitter has an oil leak from cylinder?
If there's an oil leak from the cylinder of your Champion Power Equipment Log Splitter, it could be due to several reasons. For a faulty cylinder rod seal, scored or bent cylinder rod, or faulty combination washer seal on cylinder hydraulic fitting you should contact Customer Service. If the hydraulic fitting is loose, tighten it.
What causes Champion Power Equipment Log Splitter wedge to not extend or retract?
If the wedge on your Champion Power Equipment Log Splitter will not extend or retract, check the hydraulic oil level and add as needed. For a faulty control valve or faulty hydraulic pump you should contact Customer Service.
How to fix an oil leak from hose connection on Champion Power Equipment 90720?
If you notice an oil leak from the hose connection on your Champion Power Equipment Log Splitter, it's likely due to a loose hose clamp or hydraulic fitting. Try tightening the hose clamp or hydraulic fitting to resolve the leak.
General| Brand | Champion Power Equipment |
|---|---|
| Model | 90720 |
| Category | Log Splitter |
| Language | English |
