Champion Professional 5000

Questions and Answers

K
Kimberly EllisonAug 1, 2025
What to do if my Champion Juicer motor does not start?
- D
  Dustin FowlerAug 1, 2025
  If the motor of your Champion Juicer doesn't start, there could be several reasons. First, check that the body is properly assembled to the hub. If it is, verify that the magnet in the body flange is present and, if missing, replace it. Ensure the ON/OFF switch is in the on position. Also, check the power supply, including the plug and circuit breaker. If these steps don't resolve the issue, the proximity switch or the ON/OFF switch might be faulty and require replacement. As a last resort, the juicer motor itself might be bad, necessitating a replacement.
V
Victor ChanAug 5, 2025
What to do if my Champion Professional 5000 Juicer motor stalls?
- A
  April WardAug 5, 2025
  If your Champion Juicer motor stalls, it could be because you are feeding too much material or feeding it too fast; try feeding the material more slowly. Alternatively, the auger or the restrictor might be worn and need replacement.
R
randersonAug 9, 2025
Why does material back up in the feeding tube of my Champion Juicer?
- G
  Gerald BowenAug 9, 2025
  If material backs up in the feeding tube of your Champion Juicer, it could be due to several factors. You might be feeding too much material or feeding it too quickly; if operating at a low speed, try increasing the speed. Another cause could be a plugged restrictor. To resolve this, turn off the power, remove the restrictor, and turn the power back on to clear the chamber. Then, turn off the power again, clean the restrictor, and replace it before resuming. The material you're juicing might also be too dry; if so, replace it with fresh material. Finally, ensure that the restrictor is installed, as its absence can also cause backup.
E
Emily BakerAug 13, 2025
Why is there excessive heat in the juice or pulp from my Champion Professional 5000 Juicer?
- A
  amber17Aug 13, 2025
  Excessive heat in the juice or pulp from your Champion Juicer can occur for a few reasons. You might be feeding too much material or feeding it too quickly, so try feeding material more slowly. Another cause could be a plugged restrictor; remove it, clear any blockage, and then replace it. Also, a worn auger or restrictor can cause this issue, so consider replacing them.
J
Jason PadillaAug 18, 2025
How to fix excessive or unusual noise coming from my Champion Professional 5000?
- E
  erinjohnsonAug 18, 2025
  If your Champion Juicer is making excessive or unusual noise, it could be due to improper assembly. Try re-assembling the juicer. Alternatively, there may be a damaged part that needs to be replaced.
V
vthomasAug 22, 2025
Why is my Champion Professional 5000 leaking juice at the flange of the body?
- T
  Tanya GrayAug 22, 2025
  Juice leakage at the flange of the body of your Champion Juicer could be due to a missing O-ring; install one. If an O-ring is present but damaged or worn, replace it. In some cases, the body itself might be damaged and need replacement.
J
Jeffrey WhiteAug 27, 2025
What to do if juice or pulp is slinging from the restrictor of my Champion Juicer?
- J
  Jeffrey TranAug 27, 2025
  If juice or pulp is slinging from the restrictor of your Champion Juicer, it is likely because the deflector is not installed. Install the deflector to resolve this issue.