EasyManua.ls Logo

Champion WC44 - User Manual

Champion WC44
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CHAMPION-ESSICK
Window Evaporative
Cooler Manual
~\ndow
Units
''--./
Manual Control Units
WC37-N37W
WC44-N44W
WC46 -N46W
WC50 -N50W
Remote Control Units
RWC35 RN35W
RWC46 RN46W
RWC50 RN50W
Circle the model of your cooler and
record the serial number below.
Encierre con un circulo el 11Iodelode su
enfriador y escribe el IIllmero de serie abajo.
Serial #
Numero De Serie
Read And Save These Instructions
Vea el Espanol en el interior
Evaporative Cooling
Evaporative cooling is nature's way of cooling. When air is moved
over a wet surface, water is evaporated and heat is absorbed. When
stepping out ofa swimming pool with the wind blowing, evaporative
cooling makes you feel cool, even though the air may be warm.
The human body itself is cooled primarily by the evaporation of
perspiration.
This unit works on the same principle. Air is drawn across wet
filter pads where the air is cooled
by
evaporation and then circulated
throughout the building. It is this combination of cooled air and the
movement of air over the skin which makes it feel cool.
Unlike refrigeration systems which recirculate the air,an evaporative
cooler continually brings in fresh air while exhausting old air. You
are completely replacing the air every 2 to 4 minutes by opening
windows or doors or a combination of both. The air is always fresh,
not stale, laden:with smoke and odors as happens with refrigerated
air conditioning .
Convertible K'tt Nor Shipped With (ookr
Available Upon Request At No Additional
(ost
Read Carefully All Of This Manual
Before Installing The Unit.
Lea Con Cuidado Todo Este Manual Antes
De Instalar La Unidad.
Safety Rules
1. Read these instructions carefully.
2. Unit must be in the Off Position and Unplugged from power
receptacle when installing or performing any maintenance.
3. This cooler will run on 120 volt A.C., 60 Hz (cycle) current
only,
4. Motor and pump are grounded and have an automatic thermal
overload switch which will "shutmotor offwhen it overheats. The
motor will restart automatically when it cools down.
5. Pump receptacle is for grounded evaporative cooler pump only_
Do not plug anything else into receptacle.
6. Do Not operate any fan with a damaged cord or plug. Discard fan
or return to an authorized service facility for examination and/or
repair.
7. Do Not run cord under carpeting. Do Not cover cord with throw
rugs, runners or similar coverings. Do Not route cord under
furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
&WARNING: To reduce the risk offire or electric shock, dn not
use this fan with any ~solid-state fan speed control device."
.~ ;l
110496-1 ;:",'
www.championcooler.com
1-11

Other manuals for Champion WC44

Question and Answer IconNeed help?

Do you have a question about the Champion WC44 and is the answer not in the manual?

Summary

Read And Save These Instructions

Evaporative Cooling

Explains the principle of evaporative cooling, how air is drawn over wet pads and circulated.

Safety Rules

Operation

Manual Control Units Operation

Details the operation of the rotary switch for pump, high/low cool, and high/low vent settings.

Remote Control Units Operation

Explains how to operate the unit using the remote control or buttons on the front panel.

Open Windows To Exhaust Air

Champion Air Balancing Method

Provides a method using tissue paper to determine the correct window opening for optimal air circulation.

Cooler Installation

Installing House Legs

Instructions for attaching and adjusting the house legs to the cooler unit for stability.

Mounting Cooler

Steps for mounting the cooler, including using chain hooks and ensuring a secure installation.

Connecting Water

Install Overflow Assembly

Guides on installing the overflow pipe and connecting the drain nipple for water management.

Connect Water Supply Line

Instructions for connecting the water supply using a sillcock and water valve.

Install Float Valve

Details on installing the float valve and adjusting it to maintain the correct water level.

Maintenance

Spring Start-Up Procedures

Procedures for preparing the cooler for use, including oiling bearings, checking belt tension, cleaning pump, and replacing pads.

Winter Shut Down Procedures

Steps for properly storing the cooler for the winter, including draining water and covering the unit.

Vertical Duct Conversion

Cover Grill Instructions

Instructions for using an optional plastic grill cover to block cold air.

Power Supply Disconnection

Recommendation to disconnect power for long-term storage to prevent issues.

Wiring Diagrams

Manual Control Wiring

Illustrates the wiring for units with manual controls, showing motor and pump connections.

Remote Control Wiring

Shows the wiring diagram for units equipped with remote control functionality.

Troubleshooting

Limited Warranty

Warranty Terms And Conditions

Outlines the warranty period and conditions for base assembly and components.

Warranty Exclusions

Lists items and conditions not covered by the warranty, such as pad replacement and consequential damages.

How To Obtain Service

Provides contact information and procedures for getting service or warranty claims.

General Specifications

Cabinet Dimensions

Lists the height, width, and depth dimensions for various cooler models.

Window Opening Requirements

Specifies the required window width and height for installing different cooler models.

Motor Specifications

Motor Part Numbers

Lists motor part numbers for each cooler model.

Motor Pulley Part Numbers

Provides the part numbers for the motor pulleys corresponding to each model.

Drive Belt Part Numbers

Lists the part numbers for the drive belts used with each motor.

Parts Drawing

Summary

Read And Save These Instructions

Evaporative Cooling

Explains the principle of evaporative cooling, how air is drawn over wet pads and circulated.

Safety Rules

Operation

Manual Control Units Operation

Details the operation of the rotary switch for pump, high/low cool, and high/low vent settings.

Remote Control Units Operation

Explains how to operate the unit using the remote control or buttons on the front panel.

Open Windows To Exhaust Air

Champion Air Balancing Method

Provides a method using tissue paper to determine the correct window opening for optimal air circulation.

Cooler Installation

Installing House Legs

Instructions for attaching and adjusting the house legs to the cooler unit for stability.

Mounting Cooler

Steps for mounting the cooler, including using chain hooks and ensuring a secure installation.

Connecting Water

Install Overflow Assembly

Guides on installing the overflow pipe and connecting the drain nipple for water management.

Connect Water Supply Line

Instructions for connecting the water supply using a sillcock and water valve.

Install Float Valve

Details on installing the float valve and adjusting it to maintain the correct water level.

Maintenance

Spring Start-Up Procedures

Procedures for preparing the cooler for use, including oiling bearings, checking belt tension, cleaning pump, and replacing pads.

Winter Shut Down Procedures

Steps for properly storing the cooler for the winter, including draining water and covering the unit.

Vertical Duct Conversion

Cover Grill Instructions

Instructions for using an optional plastic grill cover to block cold air.

Power Supply Disconnection

Recommendation to disconnect power for long-term storage to prevent issues.

Wiring Diagrams

Manual Control Wiring

Illustrates the wiring for units with manual controls, showing motor and pump connections.

Remote Control Wiring

Shows the wiring diagram for units equipped with remote control functionality.

Troubleshooting

Limited Warranty

Warranty Terms And Conditions

Outlines the warranty period and conditions for base assembly and components.

Warranty Exclusions

Lists items and conditions not covered by the warranty, such as pad replacement and consequential damages.

How To Obtain Service

Provides contact information and procedures for getting service or warranty claims.

General Specifications

Cabinet Dimensions

Lists the height, width, and depth dimensions for various cooler models.

Window Opening Requirements

Specifies the required window width and height for installing different cooler models.

Motor Specifications

Motor Part Numbers

Lists motor part numbers for each cooler model.

Motor Pulley Part Numbers

Provides the part numbers for the motor pulleys corresponding to each model.

Drive Belt Part Numbers

Lists the part numbers for the drive belts used with each motor.

Parts Drawing

Champion WC44 Specifications

General IconGeneral
BrandChampion
ModelWC44
CategoryAir Conditioner
LanguageEnglish

Related product manuals