www.chamsys.co.uk MagicQ Console Quick Start Manual
Page 7 of 40
Reset button Console lamp MIDI/TC ports
MQ80 Console
The picture below shows the connections on the MQ80 Compact console.
Plugging Up
x Connect the power lead to the power socket labelled LINE INPUT.
x Put the console lamp into the console lamp sockets
It is not necessary to connect a USB mouse. A mouse is only required if the touch screen becomes damaged.
DMX Connections
The MagicQ consoles have 4 direct DMX outputs on the rear of the panel so you can connect your DMX cables
direct to the console.
Alternatively you can use Ethernet and an external Ethernet to DMX converter box such as our range of SnakeSys
Ethernet to DMX Interfaces. Connect the Interface to the console Network port via a network cable.
Powering Up
To power up the console press the power switch on the back panel. The
blue LEDs around the left and right of the display should light, after a
few seconds the screen will come to life and you will see the operating
system loading.
Power Power Socket Remote USB Ports Network Ports Monitor DMX Audio
Switch
Trigger
To Next Page
Loading...
Need help?
General
