www.chamsys.co.uk MagicQ Console Quick Start Manual
Page 8 of 40
Powering Down
To power down the console it is necessary to quit the MagicQ application. The console operating system then
performs an automatic shutdown and turns itself off when complete.
To quit the MagicQ application, press the
SETUP button and then the QUIT soft button. When asked for confirmation, press the YES.
Note that just removing the power cord to the console will not have the desired effect since the internal UPS
continues to provide power.
If for some reason you are unable to power off the console then you may need to force the console to power off as
below.
Resetting the Console
Under rare circumstance it may be necessary to reset the console. To reset the console, press SETUP to go to the
Setup Window and hold SHIFT and press RESET. This performs an immediate soft reset of the console - the
MagicQ application will be running the show again within about 2-3 seconds.
If this has no effect then a hard reset may be required. Hard resets should be avoided as they bypass the operating
system shutdown procedures and may cause problems with the file system.
T
he reset switch is recessed behind the rear panel metalwork. A small screwdriver/end of a pen can be used to
gently press the button. Press and hold the button for 5 seconds to reset the front panel.
Forcing the Console to power off
If for any reason the hardware reset does not work, it may be necessary to perform a hard reset.
Switch off the console at the mains supply and press and hold the reset until it powers off completely (about 10
seconds).
To Next Page
Loading...
Need help?
General
