BLOWING OPERATION
This Wet/Dry Vac converts to a detachable blower that can be used for leaf blowing in yards, decks and patios.
To use the detachable blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
TO REDUCE THE RISK OF HEARING DAMAGE, WEAR EAR PROTECTION WHEN USING
THE VAC/BLOWER FOR EXTENDED HOURS OR WHEN USING IT IN NOISY AREAS.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove noise diffuser from the blower port. (fig. 2)
3. While squeezing the locking lever, lift the detachable blower from the vacuum lid. (fig.3 & 4)
4. Insert the adaptor into the blowing port and fit it the desired extension wands and or nozzles. (fig.5 & 6)
5. Ensure the power switch is turned off and plug into the power supply. (fig. 7)
6. Firmly hold the blower before turning it on. Turn the motor on by flipping the switch to
the ‘I’ ON position. (fig.8)
MAINTENANCE
WARNING! ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE CONTAINER.
9
To Next Page
Loading...
