Channel Master TITAN 2 Series Instructions

Product Overview
The Channel Master TITAN2 Series Preampliers offer a high gain, low
noise (CM-7777V3) for weak signal areas as well as a medium gain, low
noise (CM-7778V3) for areas with fairly strong signals. Both ampliers
improved gain is perfect if you anticipate distributing your signal with
a digital splitter to multiple outlets throughout your house as splitters
reduce the signal strength available at each output. The new housing
includes a combined VHF/UHF input and a single output for a simpler
indoor or outdoor installation. It also includes a power output LED
indicator light.
Product Features
• Amplication for both VHF and UHF bands
• High gain and low noise
• Includes switchable FM trap
• Amplies digital and analog signals
• Perfect for moderate (CM-7778V3) or weak (CM-7777V3) signal
areas
Instructions
1. Internal switch selection. If you are using a single antenna for TV
signals only, there is no need to
adjust the internal switches in the
amplier.
NOTE: If you are using the
antenna for FM radio signals as
well as TV, then select the “OUT”
position on the FM trap switch.
See Fig 1.
2. Using the U BOLT, mount the
outdoor amplier to the mast
below the antenna. See Fig 2.
3. With a short length of coaxial
cable (not included), connect the
antenna to the “INPUT” on the amplier. See Fig 2.
4. Connect the down lead coaxial cable (not included) to the connection
labeled “OUTPUT/POWER.” Cable tie the cable to the mast to prevent
stress on the connector.
5. Run the down lead coaxial cable (not included) into the home to a
location where an AC power outlet is available. Connect this coax to
the connection labeled “FROM AMP” of the power inserter. See Fig 2.
IMPORTANT: There should NOT be any signal splitters located in this
coaxial cable line between the outdoor amplier and the indoor power
supply. Splitters must be located on the “TO TV” side of the power
inserter. See Fig 3.
6. Connect the coaxial cable (not included) that distributes the signal
to the TV to the “TO TV” port of the power inserter and connect the
power supply to the “From Power” port of the power inserter with the
six foot coaxial cable (included). See Fig 2. Plug the power supply into
the AC outlet.
Titan 2 Preamplier Series Instructions
Instrucciones de la serie de preamplicadores Titan 2 / Instructions
pour la série de préamplicateurs Titan 2
Package Contents and Accessories
• Power Inserter
Insertador de energía
Inséreuse de puissance
• Power Supply
Fuente de alimentación
Source de courant
• 6 ft Coaxial Cable
Cable coaxial de 6 pies
Câble coaxial de 6 pieds
• Hardware
Hardware
Matériel
Continued on back..
Continuado en la espalda ../ Suite au dos..
CM-7777V3, CM-7778V3
CM-7777V3
CM-7778V3
Amplier Bottom View
To change settings, remove four
screws from the cover.
Para cambiar la conguración, quite cuatro
tornillos de la cubierta / Pour modier les
paramètres, retirez quatre vis du couvercle.
OUT
fuera / en
dehors
IN
en / dans
FM Switch
Interruptor de FM /
Commutateur FM
Fig 1
OUT
IN
IN
POWER INSERTER
CM-7777XPI
FROM POWER
TO TV
FROM
AMP
Fig 2
Model 7777V3 or 7778V3
Amplier, Mast Mounted
Model CM-94444 or CM-3203 Balun
(matching outdoor transformer)
Modelo CM-94444 o CM-3203 Balun (transformador
exterior a juego) / Modèle CM-94444 ou CM-3203
Balun (transformateur extérieur correspondant)
U-bolt assembly Conjunto
de perno en U / Assemblage de
boulons en U
OUTSIDE HOME/
FUERA DE CASA/ À L’EXTÉRIEUR DE LA MAISON
INSIDE HOME
/ DENTRO DE CASA/ À L’INTÉRIEUR DE LA MAISON
Power inserter
Insertador de energía /
Inséreuse de puissance
Antenna terminals
Terminales de antena
/ Bornes d’antenne
Indoor power supply
Fuente de alimentación interior /
Alimentation électrique intérieure
75 Ohm cable form power
inserter to indoor power
supply
Insertador de alimentación de
forma de cable de 75 ohmios a
fuente de alimentación / Câble de
75 ohms pour alimenter le bloc
d’alimentation interior
75 Ohm cable from antenna to amp
Cable de 75 ohmios de antena a amplicador
Câble 75 Ohm de l’antenne à l’ampli
75 Ohm cable from power inserter to TV
Cable de 75 ohmios desde el insertor de
alimentación al televisor / Câble de 75 ohms de
l’inséreuse d’alimentation au téléviseur
75 Ohm cable from amp to
indoor power inserter
Cable de 75 ohmios desde el
amplicador al insertador de
alimentación interior / Câble
75 Ohm de l’ampli à l’inséreuse
d’alimentation intérieure
PREAMP
Model CM-7777V3 or CM-7778V3
Preamplicador Modelo
CM-7777V3 o CM-7778V3
/PREAMP Modèle CM-7777V3
ou CM-7778V3
4-WAY SPLITTER MODEL CM-3214
Divisor de 4 vías Modelo CM-3214
Répartiteur 4 voies Modèle CM-3214
Typical Four Room Installation
ANTENNA
POWER INSERTER MODEL CM-7777XPI
Insertador de energía Modelo CM-7777XPI /
Inséreuse de puissance Modèle CM-7777XPI
POWER SUPPLY MODEL CM-7777XPS
fuente de alimentación Modelo CM-7777XPS
alimentation Modèle CM-7777XPS
“O” DB WALL OUTLET
(TYPICAL) / Tomacorriente
de pared “O” db (típico) /
Tomacorriente de pared “O”
db (típico)
FM SPLITTER
divisor de fm
séparateur fm
FM STEREO
Estéreo FM
Fm stéréo
DEN OR
KITCHEN
LIVING ROOM
BEDROOM
habitación / chambre
BEDROOM
habitación / chambre
TV
televisión
la télé
TV
televisión /
la télé
TV
televisión
la télé
TV
televisión / la télé
ATTIC
ática / grenier

Channel Master TITAN 2 Series Specifications

General

Brand	Channel Master
Model	TITAN 2 Series
Category	Amplifier
Language	English