Chapin Pro Series - Installing the Shoulder Strap; Wand and Pump Handle Storage; Filling the Sprayer

INSTALLING THE SHOULDER STRAP
FILLING THE SPRAYER
SPRAYER COMPONENTS & USE INFORMATION, Continued
The pump handle stores
vertically and sets into the
pump handle clip (Figure 1).
The wand is stored in the wand
clip (Figure 2).
WAND/PUMP HANDLE
Figure 2Figure 1
Figure 2
Figure 1
Strap Assembly
Tank Base
Strap Button
Link
Arm
Pump
Handle Clip
Pump
Handle
Wand
Wand Clip
Pump
Handle
Waist
Belt
4E
The backpack strap is provided with
multiple features including shoulder
strap, chest strap and waist belt (gure 1).
The top of the shoulder strap is attached
to the top of the tank and is removable.
The strap attaches to the base of the
sprayer by sliding the buttons into the
slots until they snap into place (Figure 2).
Make sure the lter basket is in place to keep debris from entering the tank.
Determine the amount of mixture needed for your application. Add the proper amount of water to the
tank. Add the proper amount of chemical to the tank (check the chemical manufacturer’s label for proper
ratio of chemical). Stir mixture in tank with a clean utensil (like a paint stirrer). The tank (4.0 G / 15 L) will
hold the rated capacity plus the chemical.
It is not necessary to completely ll the sprayer tank with each use. You can ll the tank with only the
amount needed for each application.
Shoulder
Strap
Chest
Strap