Char-Broil Performance Series User Manual

5
Leak Testing Valves, Hose and Regulator
Leak test before first use, at least once a year, and every
time the cylinder is changed or disconnected.
1. Turn all appliance control knobs to .
2. Be sure regulator is tightly connected to gas cylinder.
3. Turn on Gas. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection.
Correct before proceeding.
4. Brush soapy solution (mixture of half soap and half
water) onto hose connections.
5. If growing bubbles appear, there is a leak. Turn off gas
at cylinder immediately and check tightness of
connections. If leak cannot be stopped do not try to
repair. Call for replacement parts.
6. Always turn off gas at cylinder after performing leak
test.
IF APPLIANCE FAILS TO LIGHT
Make sure gas is turned on at cylinder. Make sure there
is gas in the cylinder.
Does the ignitor make a sparking noise?
If yes check for spark at burner.
If no spark check for damaged or loose wires.
If wires are OK check for cracked or broken electrode, replace if needed.
If wire or electrodes are covered by cooking residue,
clean electrode tip with alcohol wipe if needed.
If needed replace wires.Environmental protection
Discarded electric appliances are
recyclable
If no sound check battery. and should not be discarded in the domestic
Make sure battery is installed correctly.waste! Please actively support us in
Check for loose wire connection at module and switch.conserving resources and
protecting the
environment by returning this appliance to the
If ignitor continues to not work then use match. collection centres (if available).
TECHNICAL DATA
CHAR-BROIL, LLC
Appliance
Name
Gas Barbeque/Gas Grill
Total
Nominal
18,5 kW (1346 g/h)
Gas
Category
I3+(28-30/37)
I3B/P(30)
CAUTION
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER
If your barbeque is getting hard to light or the
flame is weak, check and clean the venturis and
burners.
Spiders or small insects are known to create
“flashback” problems by building nests and
laying eggs in the barbeque’s venturi or burner
obstructing the flow of gas. The backed-up gas
can ignite behind the control panel. This
flashback can damage your barbeque and cause
injury. To prevent flashbacks and ensure good
performance, the burner and venturi tube
assembly should be removed and cleaned
whenever the barbeque has been idle for an
extended period of time.

Char-Broil Performance Series Specifications

General

Number of Burners	4
Total Cooking Area	650 sq. in.
Material	Stainless Steel
Ignition Type	Electronic
Side Burner	Yes
Grate Material	Porcelain-Coated Cast Iron
Cooking Area	650 sq. in.
Fuel Type	Propane
Warranty	5 years