B-250 Bubble Machine QRG EN
4
Replacement
1. Disconnect this product from power.
2. With a Phillips #2 head screwdriver, unscrew the fuse holder cap from
the housing.
3. Remove the blown fuse and replace with a good fuse of the same type
and rating.
4. Screw the fuse holder cap back into place and reconnect power.
Before mounting this product, read the Safety Notes. Place bubbler on a flat,
level surface or use the mounting brackets provided. Ensure that the bubbles
are not shooting directly into anyone’s face or above heavy traf
fic areas, as
bubble fluid leaves a slippery surface. The bubble machine must not have
more than a 5° angle of inclination.
Bubble Fluid
1. Place the Bubble Machine on a level surface and loosen the thumbscrew
on the front of the unit for fluid tank access. Lift the cover.
2. Fill the tank with bubble fluid.
Note: Use of CHAUVET bubble fluid (BJU or BJG), specially
formulated for use with CHAUVET bubble machines, is
recommended. The tank capacity is 24 oz (0.7 l).
3. Lower the cover and tighten the screw.
1. Plug into a suitable wall outlet.
2. Turn on the Bubble Machine.
Note: Do not leave unused fluid in the reservoir for an extended
period. The fluid may thicken in the reservoir.
To Next Page
Loading...
