Need help?Do you have a question about the Chauvin Arnoux C.A 6115N and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Model | C.A 6115N |
| Continuity | Yes |
| RCD | Yes |
| Loop | Yes |
| Power | Yes |
| Harmonics | Yes |
| THD | Yes |
| Data logging | Yes |
| Power Supply | Rechargeable battery |
| Measurement Categories | CAT III 600V |
| AC Current Measurement | Yes (with clamp) |
| DC Current Measurement | Yes (with clamp) |
| Earth | 0.15Ω to 1999Ω |
| Communication | USB |
| Standards | IEC 61010, IEC 61557 |
| Operating Temperature | -10 °C to +50 °C |
| Storage Temperature | -20 °C to +60 °C |
| Temperature Measurement | Yes (with probe) |
Guidance on connecting the tester to installations and using appropriate cables.
Explains the two main operating modes: before and after measurement.
How to adapt general settings like standby mode, buzzer, date, and RS232 baud rate.
Verifies the presence, continuity, and voltage of the protective earth conductor.
Procedures and specifications for measuring insulation resistance.
How to test the proper working order of Residual Current Devices (RCDs).
Method for measuring earth resistance using an auxiliary rod.
Measures loop impedance, short-circuit current, fault voltage, and resistance.
How to measure resistance and perform continuity tests.
How to save and recall measurements stored in the instrument's memory.
To Next Page