Need help?Do you have a question about the Chauvin Arnoux C.A 6160 and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Model | C.A 6160 |
| Display | LCD |
| Continuity | Yes |
| Insulation | Yes |
| RCD | Yes |
| Loop | Yes |
| Earth | Yes |
| Voltage | Yes |
| Current | Yes |
| Power | Yes |
| Harmonics | Yes |
| Phase Rotation | Yes |
| Data Logging | Yes |
| PC Interface | USB |
| Measurement Categories | CAT IV 300V, CAT III 600V |
| Battery Type | 6 x AA batteries |
Provides essential safety guidelines for operating the APPLIANCE MULTITESTER.
Details the warranty terms, duration, and conditions for the APPLIANCE MULTITESTER.
Lists all the measurement functions and tests performed by the APPLIANCE MULTITESTER.
Enumerates the safety and performance standards the APPLIANCE MULTITESTER complies with.
Identifies and explains the controls, connectors, and indicators on the instrument's front panel.
Specifies parameters for high voltage dielectric strength and programmed HV tests.
Details the specifications for the burn-out test in HV mode.
Provides technical details for low resistance and continuity measurements.
Specifies parameters for voltage drop measurements scaled to 10A.
Details the specifications for insulation resistance testing.
Details the specifications for various leakage current measurements.
Provides technical specifications for functional testing of appliances.
Specifies parameters for measuring discharge time, both external and internal.
Lists general specifications including mains voltage, power, display, and protection.
Instructions and warnings for performing the withstanding test.
Instructions for performing tests with programmed voltage/time sequences.
Instructions for performing low resistance tests with various current settings.
Instructions for measuring voltage drop scaled to 10A.
Instructions for performing insulation resistance tests.
Instructions for measuring external discharge time from mains.
Instructions for measuring internal discharge time.
Details the various types of leakage current measurements.
Instructions for performing standard leakage current measurements.
Instructions for performing substitute leakage current tests.
Instructions for performing touch leakage current measurements.
Instructions for performing functional tests on appliances.
Introduction to the autotest function for automated testing.
Lists various warnings and information messages displayed during instrument operation.
Instructions on how to save and organize measurement results in memory.
Procedures for recalling previously saved measurement results.
Information on connecting the instrument to a PC via RS232.
Guide to configuring instrument settings like date, time, and baud rate.
Instructions on how to adjust the display contrast for better readability.
Guide on connecting and using the remote control pedal for operation.
Explains the function and connection of the warning lamp.
Instructions for using a barcode reader with the instrument.
Details on connecting and using the DOOR IN signal for test interlocks.
Details on connecting and using the DOOR IN signal for test interlocks.
Explains the EXT port for results and AUTOTEST sequence control.
Recommends regular calibration for instrument accuracy.
Provides guidelines on how to clean the instrument safely.
Details fuse replacement procedures and warnings.
Step-by-step instructions for installing the CE Link PC software.
Overview of the CE Link software's capabilities and basic screen.
Instructions on how to download measurement data from the instrument to the PC.
Instructions on how to open and view downloaded data files.
Instructions for printing documents and defining headers.
Steps for printing selected rows of data and defining header options.
Explains how to print individual reports for each tested object.
Window for programming instrument header information for printouts.
Introduction to the Sequence editor for creating AUTOTEST sequences.
To Next Page