Parts
To Assemble
CAUTION: Handle the Blades with care, as they are extremely sharp.
1. Before using the product for the first time, thoroughly wash the Cover, Bowl,
and Blade Assembly in hot, soapy water and dry thoroughly.
2. Ensure the product is unplugged from the electrical outlet and place the Base
on a flat, level, stable surface.
3. Place the column in the center of the
Bowl over the Shaft in the Base, aligning
the tabs in the bottom edges of the Bowl
with the indentations in the edges of the
Base.
4. Turn the Bowl clockwise until the tabs on
the Bowl slide under the tabs on the Base,
as shown.
5. While holding the Blade Assembly by the top, place it onto the column in the
Bowl and turn the Assembly until it rests about one half inch above the bottom
of the Bowl.
6. Place the Cover onto the Bowl, ensuring
that the peg in the Cover is inserted into
the top of the Blade Assembly and the
small arrow on the top of the Cover points
away from the top of the Base.
7. Turn the Cover until the arrow meets the
arrow on the top of the Base, as shown.
To Next Page
Loading...
