Batteries
Cleaning and Maintenance
Food Safety & Certification
Troubleshooting
The device comes with 2 pre-installed AAA (1.5V) batteries
located inside the sealed battery compartment.
If you see "Lo" displayed on the LCD screen, that means the
batteries are dying and should be replaced soon.
When replacing batteries, use a screwdriver to remove the
battery cover. Replace with 2 new AAA batteries, taking note
of the correct polarity (the + should rest on the spiral, the -
on the clip). Tighten the battery cover until it is snug. BUT,
do not overtighten.
To avoid potential bacteria growth and cross-contamination,
wipe the probe after each use and regularly clean the entire
body of the device.
Oils and grease should be wiped off the body and the
rotating hub. We recommend sanitary wipes or a damp
paper towel with an anti-microbial cleaning solution.
While the device is dust-proof and water-resistant up to 39"
deep for up to 40 minutes, the probe should not be rotated
while the body is submerged in, or under a stream of water.
Protect the unit from high temperatures—and DO NOT
LEAVE THE DEVICE IN AN OVEN OR ON A HOT SURFACE.
The device is not dishwasher safe.
The thermometer is certified for commercial and
professional use. It complies with stringent international
and independent food safety guidelines, such as being
free of lead, mercury, cadmium and other hazardous
substances. Certifications include CE and RoHS.
Your device might, at some point, do something you didn’t
expect. Here is a quick table with common issues, plus their
solutions.
WON'T SWITCH ON
▲
Press "HOLD" button or retract and extend probe to turn on
READING INACCURATE
▲
Calibrate thermometer or contact customer service
READING STUCK
▲
Press "HOLD" button to unlock hold function
DISPLAYS "HHH"
▲
Temperature reading exceeds maximum of 572°F (300°C)
DISPLAYS "LLL"
▲
Temperature reading below minimum of -22°F (-30°C)
SWITCH °C/°F
▲
Use switch inside battery bay to change temperature unit
DISPLAYS "LO"
▲
Battery running low, change battery
9 10
To Next Page
Loading...