5
6
USAGE FOR THE AGE GROUP I
NO-Too low
NO-Too high
Yes -Correct
The straps should go into the slots at, or the nearest slots above the height of the
child’s shoulders. Remove straps by passing them through the slots from the front to
the back of the car seat to adjust the harness：re-route the straps through the
appropriate slots.
Use of the harness system is only permitted for children of age group I ,which means
from 9kg to 18kg.
Adjusting the shoulder height(group I )
Step1.Loosen the shoulder harness
(see point 4.3). Turn the child
seat to the back,Slide the chest
belt off the harness connector.
Step3.Now thread the small belts
of the chest pads and harness into
the corresponding belt slots. Slide
the harness straps in the harness
connector.
Step2.Slide both of the shoulder
harness off the harness connector.
Step4.Slide both of the chest pads
in the chest pad connector(Fig.4).
Ensure that both of the shoulder
belts and chest belt go through
slots at the same height, and not
twisted.
If the height of your shoulder belts in child car seat is not fit for your child, adjust
the height of the shoulder belts, please proceed as follows:
paess
To Next Page
Loading...
