8
7
Step1.Place the child safety seat on the vehicle’s seat
which is fitted with 3-point safety belts, ensuring it is
firmly pressed against the car seat’s backrest.
Step2.Pull out the vehicle belt, thread the belt tongue
(incl. Vehicle belt)through the adult belt route slot to the
rear and through the back rest, through the other adult
belt route slot(on the buckle side), and allow it to lock in
place. You will hear“click”.
Step3.Place the vehicle lap belt under the arm rest.
Note:Pull the vehicle diagonal belt on the vehicle
buckle side through the car seat belt route slot and the
vehicle diagonal belt and the vehicle lap belt under the
other side of the arm rest.Make sure adult belt has not
become twisted.
click
Step4.Press your knee on the child car seat and pull
the diagonal belt along the direction as the picture
shows. Make sure that belt has not loosened.
Step5. Tighten the diagonal shoulder belt in the
direction of the automatic roll-up as possible until
there is no slack and the seat is held firmly in place.
Main load point must be up car seat buckle. The
satisfactory position of the adult safety-belt buckle
relative to the child car seat is as the following picture.
If in doubt, please contact us.
To release your child seat following the above instructions in reverse order.
Ensure that each part of the belt is tightened as possible. Make sure all the belts
position is right and has not become twisted. Also check that the cover is not
impeding the movement or fit of the belt webbing in any way.
Securing the child car seat(group I ）
To Next Page
Loading...
