18
There you must click on the product
names to open the EU declaration of
conformity.
10.2 Federal Communications
Commission (FCC) Radio
Frequency Interference
Statement
This device complies with part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may
not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
Caution: Any changes or modifications not
expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
64410016-02a_DE-EN-FR-ES-IT_MW4500.fm Seite 18 Samstag, 25. November 2017 12:20 12
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
usesandcanradiateradio
frequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions,maycauseharmfulinterferencetoradiocommunications.
However,thereisnoguaranteethatinterferencewillnot occurinaparticularinstallation.Ifthis
equipment does cause harmful interference to radio or television reception, which can be
determined by
turning the equipment off and on, the user is encouraged to try to correct the
interferencebyoneormoreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connect the equipment into an outlet on a circuit different fr om that
to which the receiver is
connected.
Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Warning:Changesormodificationstothisunitnotexpresslyapprovedbythepartresponsiblefor
compliancecouldvoidtheuser’sauthoritytooperatetheequipment.
FCCRadiationExposureStatement
Thedevicehasbeenevaluatedto
meetgeneralRFexposurerequirement.
Thedevicecanbeusedinportableexposureconditionwithoutrestriction.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
usesandcanradiateradio
frequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions,maycauseharmfulinterferencetoradiocommunications.
However,thereisnoguaranteethatinterferencewillnot occurinaparticularinstallation.Ifthis
equipment does cause harmful interference to radio or television reception, which can be
determined by
turning the equipment off and on, the user is encouraged to try to correct the
interferencebyoneormoreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connect the equipment into an outlet on a circuit different fr om that
to which the receiver is
connected.
Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Warning:Changesormodificationstothisunitnotexpresslyapprovedbythepartresponsiblefor
compliancecouldvoidtheuser’sauthoritytooperatetheequipment.
FCCRadiationExposureStatement
Thedevicehasbeenevaluatedto
meetgeneralRFexposurerequirement.
Thedevicecanbeusedinportableexposureconditionwithoutrestriction.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
usesandcanradiateradio
frequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions,maycauseharmfulinterferencetoradiocommunications.
However,thereisnoguaranteethatinterferencewillnot occurinaparticularinstallation.Ifthis
equipment does cause harmful interference to radio or television reception, which can be
determined by
turning the equipment off and on, the user is encouraged to try to correct the
interferencebyoneormoreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connect the equipment into an outlet on a circuit different fr om that
to which the receiver is
connected.
Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Warning:Changesormodificationstothisunitnotexpresslyapprovedbythepartresponsiblefor
compliancecouldvoidtheuser’sauthoritytooperatetheequipment.
FCCRadiationExposureStatement
Thedevicehasbeenevaluatedto
meetgeneralRFexposurerequirement.
Thedevicecanbeusedinportableexposureconditionwithoutrestriction.