Training Center of After-Sales Department Chery International
2. PEPS system
49
5. Notices in operation and maintenance
Operation procedure of replace PEPS module
1. Read the VIN by scanner from ECU, PEPS module, TCU, and apply the PIN from CHERY.
2. After the new PEPS module is succeed installed, press ignition (IG) switch to supply power.
3. Enter the matching interface, select ”Reset EMS ” menu. Input PIN as scanner reminding,
after ECU is successfully reset, the scanner screen shows ” Reset EMS succeed”.
4. For CVT vehicle, select ”Reset TCU” menu. Input PIN as scanner reminding, after TCU is
successfully reset, the scanner screen shows ” Reset TCU succeed”.
5. Do the operation procedure of add new key, replace EMS, replace TCU one by one.
Notice:
1. If PEPS module is not matched, there are 50 chances to shift the ignition switch power
supply mode from OFF to ON; after 50 trials, PEPS module will be disabled. Therefore, do not
turn on the power supply randomly if PEPS module is not matched.
To Next Page
Loading...
