Training Center of After-Sales Department Chery International
4. BCM
68
3. Function description
10
High beam
lamp
Working pre-conditions:
①
Turn IGN SW to ON;
②L
ow beam lamp is on;
③H
igh beam lamp switch is turned on.
When high beam lamp is working, turn IGN SW to ACC/OFF, high
beam lamp will off.
When high beam lamp is working, turn off high beam lamp switch, high
beam lamp will off.
When high beam lamp is working, turn off low beam lamp switch, high
beam lamp will off.
11
Overtake lamp
(Flash lamp)
When Flash switch is activated in any key mode, high beam lamp will
be lit.
Turn off Flash switch, the high beam lamp will off.
To Next Page
Loading...
