SAFETY
1.
Know your band saw. Read the operator's Manual carefully. Learn the operations, applications
and limitation.
2.
Use recommended accessories. Improper accessories may be hazardous.
3.
Wear proper apparel.
4.
Keep unnecessary people away.
5.
Don't overreach or stand on tool.
6.
Avoid dangerous environment. Don't use band saw in damp or wet locations. Keep work area well
lighted.
7.
Keep work area clean. Cluttered and slippery floors invite accidents.
8.
Remove adjusting keys and wrenches from band saw before turning on power.
9.
Avoid accidental starting. Mark sure switch is off before plugging in power cord.
10.
Don't force band saw. It is safe to operate at the cutting rate for which it was designed.
11.
Be specially careful while using band saws in vertical position to keep fingers and hands out of the
path of blade, both above and beneath the table.
12.
Never hand hold the material with saw in horizontal position. Always use the vise, clamp securely.
13.
Keep belt guard and wheel covers in place and in working order.
14.
Support long, heavy work from the floor.
15.
Always remember to switch off the machine when the work is completed.
16.
Disconnect power cord before adjusting. Servicing and changing blade.
17.
Check damaged parts. Damaged parts must be replaced or repaired.
18.
Moving parts should keep in alignment. All adjustments are to be made with power disconnected.
19.
Use a sharp blade and keep tool clean for best and safest performance.
20.
Safety is a combination of operator's common sense and alertness at all times when the saw is
functioning.
21.
Keeping the band saw in top condition is essential for safety.
FEATURES
1.
Special designed horizontal and vertical band saw.
2.
Offers three speeds for cutting metal plastic or wood.
3.
Shuts off automatically when material is cut.
4.
With scale for the mitering vise.
5.
No noise while operating.
6.
Casters (optional) quick and easy moving.
SPECIFICATION
1.
Capacity: at 90° 100mm round
100mmx150mm rectangular
at 45 ° 60mm round
60mmx100mm rectangular
2.
Speeds: 80-120-200 FPM 60HZ (65-95-165 FPM 50HZ)
3.
Motor: 1/3HP or 1/2HP 1700 RPM 60HZ (1400RPM 50 HZ)
4.
Blades: 60 1/4"x1/2"x1/40"(1530mmx13mmx0.6mm)
5.
Blades wheels: 7
3
/
8
" (187mm) High strength flanged cast iron.
2
1580
To Next Page
Loading...