Chevrolet 1997 S10 Pickup User Manual

4. Insrall a new bulb?
3. Remove. the bulb.
and tighten the screws.
If equipment--such as a cap or camper is installed on
your vehicle, a center high-mounted stoplamp feed wire
is provided along the driver's s.iid& rear fram-e. This wire
,-rshould be used to install a center high-mounted
'-stoplanip in the cap 'or c.mper;
Taillamps
1 .. Open the tailgate;
2. Re,move the-.screws fr~m
the lamp assembly nea
the tailgate latch..
3. Pull the assembly away from the pickup side. panel.
4. Turn the socket countexclockwise to remove it. Push
the tab. i-n while you turn the s,ocket.
5. Pull the bulb out.
,6. Push the new bulb into the socket-.
7. Put the scrcket into the assembly and.ttlrn the s:ocket
clockwk until it locks into-place-:
8. Rep1.ac-e-the assembly. Install and tighten the screws,
-9. Close the tailgate.
6-40

Chevrolet 1997 S10 Pickup Specifications

General

Brand	Chevrolet
Model	1997 S10 Pickup
Category	Automobile
Language	English