To
signal a lane change, just raise or lower the lever
until the arrow
starts
to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release
it.
As
you signal a turn or
a
lane change, if the
arrows
don’t flash but just stay on, a signal bulb may be burned
out and other drivers won’t
see
your turn signal.
If
a
bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a
turn,
check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned-out bulbs.
Lamps
On
Reminder
If
you
turn
the ignition
off,
remove the key, open the
door and leave the lamps on, a tone will remind you
to
turn
off your lamps.
Headlamp High/Low Beam Changer
First, you must have the headlamps on.
For
high beams,
push the
turn
signal lever toward the instrument panel.
When the high beams are
on, a light on the instrument
panel also will be on. It will
go
off
when you switch to
low beam.
To
switch back to low beams, pull the lever toward you.
Flash-to-Pass
With the lever in the low-beam position, pull the lever
toward you to momentarily switch to high beam (to
signal that you are going to pass). When you release the
lever,
the
headlamps will return to low-beam operation.
2-31
To Next Page