Windshield WiperNasher Lever
The lever on the right side
of
the steering column
controls the windshield wipers and washers.
Move the wiper switch to the position
you
want:
OFF:
The wipers are
off.
INT
Intermittent wiper operation.
In
light rain or snow,
you might want to use this position rather than
continuous wiping.
LO:
The wipers will run continuously at
low
speed.
HI:
The wipers will run continuously
at
high speed.
Be
sure
to
clear ice and snow
from
the wiper blades
before using them.
If
they’re frozen to the windshield,
carefully loosen
or
thaw them.
If
your blades do
become damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers.
A
circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
Windshield Washer
Pull the wipedwasher lever toward you to spray
washer fluid on the windshield. The spray will continue
until you release
the
lever. This will also
turn
on
the
low-speed wipers
for
two wiper cycles. See “Windshield
Washer Fluid” in the Index.
A
CAUTIC
-V:
I-=--
In
freezing weather, don’t use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice
on
the windshield, blocking
your
vision.
M
2-32
To Next Page