Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness of the
hills. When going downhill, you may have to brake
or shift to a lower gear to keep your speed down.
Of course, applying the brake takes you out of cruise
control. Many drivers find this to be too much trouble
and do not use cruise control on steep hills.
Ending Cruise Control
There are two ways to turn off the cruise control:
• Step lightly on the brake pedal or push the clutch
pedal, if you have a manual transmission vehicle.
• Move the cruise switch to OFF.
The Driver Information Center (DIC) will display the
message CRUISE DISENGAGED.
Erasing Speed Memory
When you turn off the cruise control or the ignition,
cruise control set speed memory is erased.
Exterior Lamps
The exterior lamp switch on the turn signal/multifunction
lever operates the headlamps.
The exterior lamp switch has three positions:
OFF: Turn the switch to this position to turn off all
lamps, except the Daytime Running Lamps (DRL).
; (Parking Lamps): Turn the switch to this position
to turn on the parking lamps, together with the
following:
• Taillamps
• Parking Lamps
• Sidemarker Lamps
3 (Headlamps): Turn the switch to this position to
turn on the headlamps, together with the previously
listed lamps.
3-13
To Next Page
Loading...
Need help?
General
