Arming with Your Key
Your alarm system will arm when you use your key to
lock the driver’s door. The security light will flash to
let you know the system is arming. After all doors and
the liftgate are closed and locked, the security light
will begin flashing at a very slow rate to let you know the
system is armed. If you would like your key not to
arm the system, see DIC Vehicle Personalization
(Uplevel Only) on page 3-69.
Arming Confirmation
If remote unlock confirmation is on, the turn signal
lamps will flash briefly to let you know when your alarm
system has disarmed. If you would not like the turn
signal lamps to flash, see DIC Vehicle Personalization
(Uplevel Only) on page 3-69.
Disarming with the Remote Keyless
Entry Transmitter
Your alarm system will disarm when you use your
remote keyless entry transmitter to unlock the doors.
The security light will stop flashing to let you know the
system is no longer armed.
Disarming with Your Key
Your alarm system will disarm when you use your key
to unlock the driver’s door. The security light will
stop flashing to let you know the system is no longer
armed. If you would like your key not to disarm the alarm
system, see DIC Vehicle Personalization (Uplevel
Only) on page 3-69.
PASS-Key
®
III
Your PASS-Key
®
III system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
2-28
To Next Page
Loading...
